Saturday, November 2, 2019

Lab report paraphrase Example | Topics and Well Written Essays - 250 words

Paraphrase - Lab Report Example In addition to that, the same outputs must conclude in each of the NAND and BOR circuits. The properties were tested at the time of functional simulation, and proven during the hardware testing when the light on the FPGA board was programmed to turn on given there was an output of 1. The timing delay was also tested through the timing simulation. The outcome of the waveform was that it worked successfully the way it was supposed to. The design of the three circuits was made as an RTL schematic and each of the circuits had specific settings as it’s shown in figure 1.1. The second step was to transfer the three circuit’s design through USB to the FPGA for them to be tested as to whether they work properly or not. For Y1, Y2, and Y3 (as shown in Figure 1.2), 16 possibility variables were included. The graph as represented in Figure 1.3 is called the functional simulation. The functional simulation graph reveals the output results of the given variables of the functions. This simulation occurs in such a way that bumps in the graph represents the function when it equates to 1, while the straight lines represents the function when it equates to 0. Inclusively, the graph proves the assertion that NAND and BOR circuits have the same outcome (i.e. Give the same output). As shown in Figure 1.4, the function variables are represented in a timely interval and there variations with time. As a result the representation information that is accrued from the circuit can be obtained accordingly within the graph. Following the same logic as per the functional simulation, the bumps in the graph represents the function when it equates to 1, while the straight lines represents the function when it equates to 0. Of importance to note is that the graph also reveals propagation delay that occurs each time variables go through the logic gates in the timing simulation. By thoroughly following the steps as in the lab manual provided, the three

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.